DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


| EURO-OBD (EUROPEAN SPEC.) |
The emission control system components
The powertrain control components which affect vehicle emissions
The computer
In addition, the applicable Diagnostic Trouble Codes (DTCs) prescribed by ISO 15765-4 are stored in the ECM memory. If the malfunction does not reoccur in 3 consecutive trips, the MIL turns off automatically but the DTCs remain stored in the ECM memory.
To check DTCs, connect the intelligent tester or OBD scan tool to the Data Link Connector 3 (DLC3) of the vehicle.
The DTCs and freeze frame data can be cleared using the scan tool (Click here).
| M-OBD (EXCEPT EUROPEAN SPEC.) |
OBD regulations require that the vehicle's on-board computer illuminate the MIL on the instrument panel when the computer detects a malfunction in:
The emission control system/components
The powertrain control components which affect vehicle emissions
The computer
In addition, the applicable DTCs are stored in the ECM memory. If the malfunction does not recur in 3 consecutive trips, the MIL turns off automatically but the DTCs remain stored in the ECM memory.
| NORMAL MODE AND CHECK MODE |
| 2 TRIP DETECTION LOGIC |
| FREEZE FRAME DATA |
| INSPECT BATTERY VOLTAGE |
- Battery voltage:
- 11 to 14 V
| CHECK MIL |
Check that the MIL illuminates when the ignition switch is turned to ON.
If the MIL does not illuminate, there is a problem in the MIL circuit (Click here).Check that when the engine is started, the MIL turns off.
| ALL READINESS |
- HINT:
- With "All Readiness", it is possible to check whether or not the DTC judgment has been completed by using the intelligent tester.
- Check "All Readiness" after reproducing malfunction conditions or for validation after finishing repairs.
- With "All Readiness", it is possible to check whether or not the DTC judgment has been completed by using the intelligent tester.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear the DTCs.
Perform the DTC judgment driving pattern to run the DTC judgment.
Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.
Input the DTCs to be confirmed.
Check the DTC judgment result.
DTC Judgment Result Tester Display
Description
NORMAL
- DTC judgment completed
- System normal
ABNORMAL
- DTC judgment completed
- System abnormal
INCOMPLETE
- DTC judgment not completed
- Perform driving pattern after confirming DTC enabling conditions
N/A
- Unable to perform DTC judgment
- Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit
- DTC judgment completed