HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use these procedures to troubleshoot the audio and visual system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
- When troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
- Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
- The following 5 items are important points in problem analysis:
What
Vehicle model, system name
When
Date, time, occurrence frequency
Where
Road conditions
Under what conditions?
Driving conditions, weather conditions
How did it happen?
Problem symptoms
| |||||
| 3.INSPECT BATTERY VOLTAGE |
Measure the battery voltage.
- Standard voltage:
- 11 to 14 V
- If the voltage is below 11 V, recharge or replace the battery before proceeding.
| |||||
| 4.CHECK CABIN |
Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.
- OK:
- Condensation is not likely being produced and the temperature is not high or extremely low.
- HINT:
- A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
- The audio and visual system may not operate normally when the temperature is -20°C (-4°F) or less, or 65°C (149°F) or higher.
- A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
|
|||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
Refer to the Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
|
|||||
| |||||
| 6.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM |
Terminals of ECU (Click here).
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
| |||||