2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Vehicle Position Mark Deviates Greatly

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

INSPECTION PROCEDURE


1. CHECK CABIN
  1. Check the cabin for any object that might interrupt radio reception or additional devices which use radio waves on the instrument panel. If such an object exists, remove it and check if the GPS mark reappears.

    HINT:
    The GPS uses extremely weak radio waves originating from satellites. If the signal is interrupted by obstructions or other radio waves, the GPS may not be able to properly receive the signal.

    OK:
    The GPS mark appears.



NG
Go to step 2
OK

NORMAL OPERATION

2. CHECK SURROUNDINGS

  1. Check if the vehicle is in a location where GPS signal reception is poor. If the vehicle is in such a place, relocate the vehicle and check if the GPS mark reappears.

    HINT:
    The GPS uses 24 satellites in 6 orbits. At any point in time, 4 satellites should be able to pinpoint your vehicle. However, GPS signals may not reach the vehicle due to influence from the surroundings, vehicle direction and time. For examples, see the following illustration.

    I100196E28

    OK:
    The GPS mark is displayed.

    Text in Illustration 
    *a
    Example
    *b
    In a tunnel
    *c
    In a building
    *d
    Under an overpass
    *e
    On a forest or tree-lined path
    *f
    Between tall buildings
    *g
    Under a cliff or overhang
    -
    -



NG
Go to step 3
OK

SYSTEM RETURNS TO NORMAL

3. CHECK GPS INFORMATION (OPERATION CHECK)
E277814
  1. Enter the "System Sensors Check" screen. Refer to Check System Sensors in Operation Check (Click here).

  1. Check how many of the following codes appear in the "Reception number" column.

    HINT:
    T or P appears.

    OK:
    At least 3 codes appear.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK


4. CHECK VEHICLE SIGNAL (OPERATION CHECK)
  1. Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (Click here).

  1. E225801
    Check that the display changes between ON and OFF according to the shift lever operation.
    OK 
    Shift Lever Position
    Display
    Except R
    OFF
    R
    ON

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
GO TO "REVERSE SIGNAL DOES NOT CHANGE IN VEHICLE SIGNAL CHECK MODE" IN PROBLEM SYMPTOMS TABLE
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Poor Sound Quality in All Modes (Low Volume) (from Aug 2014)Vehicle Position Mark Deviates Greatly (from Aug 2014) →