2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Display does not Dim when Light Control Switch is Turned ON

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

INSPECTION PROCEDURE


1. CHECK IMAGE QUALITY SETTING
  1. Display the "Display" screen.

  1. Turn the light control switch to the tail or head position.

  1. Check if "Day Mode" on the display adjustment screen is on.

    OK:
    "Day Mode" setting is off



NG
TURN "Day Mode" SETTING OFF
OK


2. CHECK VEHICLE SIGNAL (OPERATION CHECK)
E278187
  1. Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (Click here)]

  1. Check that the display for "TAIL" changes between ON and OFF according to the light control switch operation.

    OK:
    Light Control Switch
    Display
    Tail or head
    ON
    Off
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.

  1. Check that the display for "ADIM/TCAN" changes between DIM and BRIGHT according to the light control switch operation.

    OK:
    Light Control Switch
    Display
    Tail or head
    DIM
    Off
    BRIGHT



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)


← Illumination for Panel Switch does not Come on with Tail Switch ON (from Aug 2014)Display does not Dim when Light Control Switch is Turned ON (from Aug 2014) →