When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).
1. CHECK TOUCH PANEL
Check for foreign matter on the display.
OK:
The display is clean.
NG
CLEAN DISPLAY AND RECHECK TOUCH PANEL
OK
2. CHECK TOUCH SWITCH (OPERATION CHECK)
Enter the "Touch Switch Check" screen. [Refer to Check Touch Switch in Operation Check (Click here)]
Touch the display in the area where the switch malfunction occurs.
OK:
A "+" mark appears at the touched position.
NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)