2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Voice is not Recognized

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

INSPECTION PROCEDURE

HINT:
When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).


1. CHECK CONDITION
  1. Refer to the owner's manual and follow its instructions to check that the voice recognition level of the system is not too low for a particular voice.

    Result 
    Result
    Proceed to
    System voice recognition level is low with any voice.
    A
    System voice recognition level is low only for a particular voice.
    B

    HINT:
    System voice recognition level varies depending on voice and pronunciation. This is not a malfunction.



B
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
A


2. CHECK MICROPHONE (OPERATION CHECK)

  1. E268457E02
    Enter the "Microphone Check" screen. [Refer to Check Mic & Voice Recognition in Operation Check (Click here)]

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Select the recording switch and perform voice recording.

    1. Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.
    2. Voice can be recorded up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)


← Voice Guidance does not Function (from Aug 2014)Voice is not Recognized (from Aug 2014) →