P0560 System Voltage
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The battery supplies power to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, the TCM data is cleared and the TCM determines that there is a malfunction in the power supply circuit. The next time the engine is started, the TCM will illuminate the MIL and store the DTC.| DTC Code |
DTC Detection Condition |
Trouble Area |
| P0560 |
Open in the TCM back-up power source circuit (1-trip detection logic). |
|
- HINT:
- If DTC P0560 is stored, the TCM does not store other DTCs.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK DTC OUTPUT (ECD SYSTEM DTC P0560) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs using the intelligent tester.
Result Result
Proceed to
DTCs are not output
A
DTC P0560 (ECD system) is output (w/ DPF)
B
DTC P0560 (ECD system) is output (w/o DPF)
C
|
|
||||
|
|
||||
| A | |
| 2. CHECK TCM (POWER SOURCE, BODY GROUND) |
Disconnect the G69 and G70 TCM connectors.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
G70-5 (BATT) - G69-1 (E1)
Always
11 to 14 V
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G69-1 (E1) - Body ground
Always
Below 1 Ω
| *a |
Rear view of wire harness connector (to TCM) |
|
|
||||
| OK | ||
| ||
