2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

Starter Signal Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

While the engine is being cranked, current flows from terminal ST1 of the ignition switch assembly*1 or terminal STAR of the power management control ECU*2 to the park/neutral position switch assembly*3 or clutch pedal switch assembly (for Clutch Start System)*4 and also flows to terminal STA of the ECM (STA Signal).
*1: w/o Entry and Start System
*2: w/ Entry and Start System
*3: for Automatic Transmission
*4: for Manual Transmission

WIRING DIAGRAM

Refer to DTC P0617 (Click here).

INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses of circuits related to this system before performing the following inspection procedure.
  2. After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).

HINT:
This chart is based on the premise that the engine can crank normally. If the engine cannot crank normally, proceed to Problem Symptoms Table (Click here).


1. READ VALUE USING INTELLIGENT TESTER (STARTER SIGNAL)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / Starter Signal.

  1. Read the value.

    OK:
    Ignition Switch Condition
    Starter Signal
    ON
    OFF
    START
    ON



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (STARTER RELAY (ST) - ECM)
  1. Remove the ST relay from the engine room relay block.

  1. Disconnect the ECM connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ST relay terminal 2 - G57-6 (STA)
    Always
    Below 1 Ω
    ST relay terminal 2 or G57-6 (STA) - Body ground
    Always
    10 kΩ or higher

  1. Reinstall the starter relay (ST).

  1. Reconnect the ECM connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (STARTER RELAY (ST) - ECM)
OK

REPLACE ECM (Click here)


← Starter Signal Circuit (Aug 2013 – Jul 2014)Injector Circuit (Aug 2013 – Jul 2014) →