2013-2015 Land Cruiser Prado · Service Manual Brake

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE VACUUM PUMP PULLEY

  1. C214623
    Using soft jaws, place the vacuum pump in a vise, and then remove the pulley lock nut and pulley.


2. REMOVE VACUUM PUMP VACUUM HOSE UNION

  1. C214624E01
    Using SST, hold the check valve assembly, and then remove the union bolt, vacuum hose union and 2 gaskets.
    SST
    09922-10010  


3. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY

  1. C214625
    Remove the check valve assembly and gasket.


4. REMOVE VACUUM PUMP END COVER

  1. C214626
    Remove the 4 screws and end cover.


5. REMOVE VACUUM PUMP SHAFT

  1. C214627
    Using a plastic-faced hammer, tap out the vacuum pump shaft together with the bearing.


6. REMOVE STOP RING
  1. Remove the stop ring from the vacuum pump shaft.


7. REMOVE VACUUM PUMP BEARING

  1. C214628
    Using a press, press out the bearing from the rotor shaft.


8. REMOVE VACUUM PUMP BLADE

  1. C214629
    Remove the 2 screws and end plate.

  1. C214633E01
    Remove the rotor and 5 pump blades.


9. REMOVE O-RING
  1. Remove the O-ring from the case.


10. REMOVE OIL SEAL

  1. C214630
    Using a screwdriver, remove the oil seal.

← REMOVAL (from Aug 2013)INSPECTION (from Aug 2013) →