2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE COOLER COMPRESSOR BRACKET

  1. E195745E01
    Detach the clamp.
    Text in Illustration 
    *A
    except Model Code KDJ150L-GKFEYV, KDJ150L-GKAEYV
    *B
    Model Code KDJ150L-GKFEYV, KDJ150L-GKAEYV
    *C
    for Cold Area Specification Vehicles

  1. Remove the screw and cooler bracket.


2. REMOVE MAGNETIC CLUTCH ASSEMBLY
  1. Place the cooler compressor in a vise.

  1. E195746E01
    Using SST, hold the magnet clutch hub.
    SST
    09985-00270  
    Text in Illustration 
    *A
    except Cold Area Specification Vehicles
    *B
    for Cold Area Specification Vehicles

  1. Remove the bolt, magnet clutch hub and magnet clutch washers.

    HINT:
    There is no set number of magnet clutch washer since they are used for adjusting.

  1. E108882
    Using a snap ring expander, remove the snap ring and magnet clutch rotor.

    NOTICE:
    Take care not to damage the seal cover of the bearing when removing the snap ring.

  1. Disconnect the connector.

  1. E108883
    Using a snap ring expander, remove the snap ring and magnet clutch stator.

← REMOVAL (from Aug 2013)INSPECTION (from Aug 2013) →