2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for LHD)

  1. E197600E01
    Operate the front wipers while spraying washer fluid on the windshield glass. Make sure that the front wipers function properly and the wipers do not come into contact with the vehicle body.

    Standard:
    Area
    Standard Condition
    A
    47.5 mm (1.87 in.)
    B
    30.4 mm (1.20 in.)
    C
    9.5 mm (0.374 in.)
    Text in Illustration 
    *1
    Moulding Edge

  1. E201882E01
    Stop the front wiper motor and link assembly operation.
    Text in Illustration 
    *A
    for RH Side
    *B
    for LH Side
    *1
    Cowl Side Seal Edge
    *2
    Louver Edge

  1. Check the automatic stop position.

    OK:
    The front wipers stop at the positions shown in the illustration.

    Standard:
    Area
    Standard Condition
    a
    35.6 to 55.6 mm (1.40 to 2.19 in.)
    b
    18.9 to 38.9 mm (0.744 to 1.53 in.)

    If the result is not as specified, remove and reinstall the wiper arm and blade assembly, and then perform the on-vehicle inspection described above to inspect the wiper motor and link assembly again. If the result is not as specified again, inspect the wiper motor and link assembly with it removed from the vehicle body (Click here).


INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for RHD)

  1. E197601E01
    Operate the front wipers while spraying washer fluid on the windshield glass. Make sure that the front wipers function properly and the wipers do not come into contact with the vehicle body.

    Standard:
    Area
    Standard Condition
    A
    47.5 mm (1.87 in.)
    B
    30.4 mm (1.20 in.)
    C
    13.0 mm (0.512 in.)
    Text in Illustration 
    *1
    Moulding Edge

  1. E201883E01
    Stop the front wiper motor and link assembly operation.
    Text in Illustration 
    *A
    for LH Side
    *B
    for RH Side
    *1
    Cowl Side Seal Edge
    *2
    Louver Edge

  1. Check the automatic stop position.

    OK:
    The front wipers stop at the positions shown in the illustration.

    Standard:
    Area
    Standard Condition
    a
    35.6 to 55.6 mm (1.40 to 2.19 in.)
    b
    18.9 to 38.9 mm (0.744 to 1.53 in.)

    If the result is not as specified, remove and reinstall the wiper arm and blade assembly, and then perform the on-vehicle inspection described above to inspect the wiper motor and link assembly again. If the result is not as specified again, inspect the wiper motor and link assembly with it removed from the vehicle body (Click here).

← COMPONENTS (from Aug 2013)REMOVAL (Aug 2013 – Jul 2014) →