2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT FOR COOLANT LEAK

HINT:
  1. The sliding surface inside the engine water pump assembly is lubricated by engine coolant. As some engine coolant is discharged during normal operation, coolant residue (solids) may be found on the drain plug or the bottom of the engine water pump assembly. Engine coolant may leak if foreign matter enters the engine water pump assembly, however the sealing performance will recover when the foreign matter is pushed out or breaks into fine pieces.
  2. Before performing this inspection, check that there is no coolant leaking from any parts other than the water pump. If there are leaks, inspect those areas.
  3. Perform this inspection when the engine is cold.

  1. Visually check the engine water pump assembly.

    1. Check that engine coolant is not dripping from the engine water pump assembly.

      HINT:
      1. If engine coolant is dripping, replace the engine water pump assembly.
      2. If engine coolant is not dripping, perform the following check.


REMOVE FAN SHROUD
  1. Remove the fan shroud (Click here).


INSPECT WATER PUMP ASSEMBLY

  1. A174302E02
    Visually check the air hole and water hole for coolant leakage.
    Text in Illustration 
    *1
    Water Hole
    *2
    Air Hole
    If leakage is found, replace the water pump assembly.

  1. Turn the pulley and check that the water pump bearing moves smoothly and quietly.
    If necessary, replace the water pump assembly.


INSPECT FLUID COUPLING ASSEMBLY

  1. A224910
    Remove the 4 nuts and fan.

  1. A224914
    Check the fluid coupling for damage or silicon oil leaks.
    If necessary, replace the fluid coupling.

  1. Install the fan with the 4 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


INSTALL FAN SHROUD
  1. Install the fan shroud (Click here).

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2013) →