2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT WATER INLET WITH THERMOSTAT

HINT:
A174313
The valve opening temperature is inscribed on the thermostat.

  1. Immerse the thermostat in water, and then gradually heat the water.

  1. Check the valve opening temperature of the thermostat.

    Standard valve opening temperature:
    80 to 84°C (176 to 183°F)

    If the valve opening temperature is not as specified, replace the water inlet with thermostat.

  1. A174314E02
    Check the valve lift.

    Standard valve lift:
    8.0 mm (0.315 in.) or more at 95°C (203°F)

    Text in Illustration 
    *a
    Valve Lift
    If the valve lift is not as specified, replace the water inlet with thermostat.

  1. Check that the valve is fully closed when the water inlet with thermostat is at a low temperature (below 77°C (171°F)).
    If not fully closed, replace the thermostat.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →