2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT FRONT NO. 2 SPEAKER ASSEMBLY

  1. for JBL Made:

    1. E180661E16
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Always
      1.6 to 2.2 Ω

      If the result is not as specified, replace the front No. 2 speaker assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Front No. 2 Speaker Assembly)

  1. except JBL Made:

    1. E180661E16
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Always
      4 Ω

      If the result is not as specified, replace the front No. 2 speaker assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Front No. 2 Speaker Assembly)


INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for 6 Speakers)
  1. When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a new one and check that the malfunction disappears.

    OK:
    Malfunction disappears.

    HINT:
    1. Connect the connectors to the right and left front No. 2 speaker assemblies.
    2. When there is a possibility that either the right or left front No. 2 speaker assembly is defective, inspect by interchanging the right one with the left one.
    3. Perform the inspection above on both the LH and RH sides.


INSPECT FRONT NO. 4 SPEAKER ASSEMBLY
  1. for JBL Made:
    Temporarily replace the front No. 4 speaker assembly with a new or normally functioning one.

    OK:
    Malfunction disappears.

  1. except JBL Made:

    1. E180661E16
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Always
      6 Ω

      If the result is not as specified, replace the front No. 4 speaker assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Front No. 4 Speaker Assembly)

← REMOVAL (from Aug 2014)INSTALLATION (Aug 2013 – Jul 2014) →