2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE FRONT NO. 1 ASSIST GRIP PLUG LH

B238741E01

HINT:
Use the same procedure for the other front No. 1 assist grip plug.

  1. Using a screwdriver, detach the 2 claws and remove the front No. 1 assist grip plug.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


4. REMOVE NO. 1 ASSIST GRIP

B238742

HINT:
Use the same procedure for the other No. 1 assist grip.

  1. Remove the 2 bolts.

  1. Detach the 2 claws and remove the No. 1 assist grip.


5. REMOVE FRONT PILLAR GARNISH LH

B238743
  1. Detach the 3 guides and remove the front pillar garnish.

  1. B238744E01
    w/ Curtain Shield Airbag:
    Protect the curtain shield airbag assembly.

    1. Completely cover the airbag with a cloth or nylon sheet and secure the ends of the cover with adhesive tape as shown in the illustration.

      NOTICE:
      Cover the curtain shield airbag with a protective cover as soon as the front pillar garnish is removed.

      Text in Illustration 
      *1
      Curtain Shield Airbag Assembly
      *2
      Adhesive Tape
      *3
      Protective Cover


6. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

B238223E01
  1. Put protective tape around the No. 1 instrument panel speaker panel.

  1. Using a screwdriver, detach the 2 clips, claw, and 2 guides and remove the No. 1 instrument panel speaker panel.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


7. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY

  1. B239150
    Remove the 2 screws.

  1. Disconnect the connector and remove the front No. 2 speaker assembly.

    NOTICE:
    Do not touch the cone of the speaker.


8. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type)
(Click here)

9. REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL

B361965
  1. Detach the 8 clips and 2 guides and remove the upper instrument cluster finish panel.


10. REMOVE FRONT NO. 4 SPEAKER ASSEMBLY

  1. B239154
    Remove the 2 screws.

  1. Disconnect the connector and remove the front No. 4 speaker assembly.

    NOTICE:
    Do not touch the cone of the speaker.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →