2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

REPAIR

Removal / installation · Vehicles built from Aug 2013


1. INSPECT WINDOW GLASS ANTENNA WIRE

NOTICE:
B066134E15
When cleaning the glass, use a soft, dry cloth and wipe the glass in the direction of the wire. Take care not to damage the wires. Do not use detergents or glass cleaners with abrasive ingredients. When measuring voltage, wind a piece of tin foil around the tip of the probe and press the foil against the wire with your finger as shown in the illustration.
Text in Illustration 
*1
Antenna Wire
*2
Tin Foil
*3
Tester Probe

  1. E032576
    Check the voltage at the center of each wire as shown in the illustration.


2. REPAIR WINDOW GLASS ANTENNA WIRE

  1. B063722E17
    Clean the broken wire tips with grease, wax and silicone remover.
    Text in Illustration 
    *a
    Repair Point
    *1
    Antenna Wire
    *2
    Masking Tape

  1. Place masking tape along both sides of the wire to be repaired.

  1. Thoroughly mix the repair agent.

  1. B063723E13
    Using a fine tip brush, apply a small amount of the repair agent to the wire.
    Text in Illustration 
    *a
    Repair Point
    *1
    Fine Tip Brush

  1. After a few minutes, remove the masking tape.

    NOTICE:
    Do not allow electricity to flow in the antenna wire for at least 24 hours.

← INSTALLATION (from Aug 2014)COMPONENTS (from Aug 2013) →