HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Aug 2013
*: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.CONNECT INTELLIGENT TESTER TO DLC3* |
- HINT:
- If the display indicates a communication fault in the tester, inspect the DLC3.
| |||||
| 4.CHECK DTC AND FREEZE FRAME DATA* |
- HINT:
- Record or print DTCs and freeze frame data, if necessary.
| |||||
| 5.CLEAR DTC AND FREEZE FRAME DATA* |
| |||||
| 6.CONDUCT VISUAL INSPECTION |
| |||||
| 7.SET CHECK MODE DIAGNOSIS* |
| |||||
| 8.CONFIRM PROBLEM SYMPTOMS |
- HINT:
- If the engine does not start, first perform the "Check DTC" procedures and "Conduct Basic Inspection" procedures below.
| Result |
Proceed to |
| Malfunction does not occur |
A |
| Malfunction occurs |
B |
|
|||||
| |||||
| 9.SIMULATE SYMPTOMS |
| |||||
| 10.CHECK FOR DTC* |
| Result |
Proceed to |
| DTC output |
A |
| No DTC output |
B |
|
|||||
| |||||
| 11.REFER TO DTC CHART |
| |||||
| 12.CONDUCT BASIC INSPECTION |
| Result |
Proceed to |
| Malfunctioning parts not confirmed |
A |
| Malfunctioning parts confirmed |
B |
|
|||||
| |||||
| 13.REFER TO PROBLEM SYMPTOMS TABLE |
| Result |
Proceed to |
| Malfunctioning circuit confirmed |
A |
| Malfunctioning parts confirmed |
B |
|
|||||
| |||||
| 14.CHECK ECM POWER SOURCE CIRCUIT |
| |||||
| 15. CONDUCT CIRCUIT INSPECTION |
| Result |
Proceed to |
| Malfunction not confirmed |
A |
| Malfunction confirmed |
B |
|
|||||
| |||||
| 16.CHECK FOR INTERMITTENT PROBLEMS |
| |||||
| 17.CONDUCT PARTS INSPECTION |
| |||||
| 18.IDENTIFY PROBLEM |
| |||||
| 19.ADJUST AND/OR REPAIR |
| |||||
| 20.CONDUCT CONFIRMATION TEST |
| |||||