2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE FRONT BUMPER COVER LOWER
  1. Remove the clip, 5 bolts and front bumper cover lower.


2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. A224743
    Remove the 4 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.


3. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


A223311E01
Text in Illustration 
*1
Reservoir Cap
*2
Radiator Cap
*3
Cylinder Block Drain Cock Plug
*4
Radiator Drain Cock Plug

  1. G038197E02
    Install a vinyl hose to the radiator side.
    Text in Illustration 
    *1
    Vinyl Hose

  1. G038198E02
    Install a vinyl hose to the engine side.
    Text in Illustration 
    *1
    Vinyl Hose

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap and drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the cylinder block drain cock plug and drain the coolant from the engine.


4. REMOVE AIR CLEANER AND HOSE

  1. A223920
    Detach the 3 clamps and disconnect the mass air flow meter connector.

  1. A223921
    Detach the 4 clamps.

  1. Loosen the hose clamp and remove the air cleaner and hose.


5. REMOVE INTAKE AIR CONNECTOR

  1. A273728
    w/ Manifold absolute pressure sensor:

    1. Disconnect the air pressure sensor connector.

    2. Detach the 2 clamps.

    3. Disconnect the vacuum hose.

  1. A224325
    Disconnect the No. 2 ventilation hose.

  1. Detach the wire harness clamp.

  1. G037696E01
    Disconnect the vacuum hose.

  1. A224324
    Loosen the hose clamp.

  1. Remove the 3 bolts and intake air connector.


6. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

  1. G037698E01
    Disconnect the water by-pass hose.

  1. Disconnect the No. 2 water by-pass hose.

  1. Disconnect the throttle position sensor and throttle control motor connector.

  1. G037699E01
    for Type A:
    Remove the 2 bolts, 2 nuts and throttle body with motor.

  1. for Type B:
    Remove the 4 bolts and throttle body with motor.

  1. G037700E01
    Remove the gasket from the intake manifold.

← ON-VEHICLE INSPECTION (from Aug 2013)INSPECTION (from Aug 2013) →