DATA LIST / ACTIVE TEST
System information · Vehicles built from Aug 2013
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
According to the display on the intelligent tester, read the Data List.
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
ACC SW
Ignition switch status / ON or OFF
ON: Ignition switch ACC
OFF: Ignition switch off
-
IG SW
Ignition switch status / ON or OFF
ON: Ignition switch ON
OFF: Ignition switch off
-
RR Door Courtesy SW*1
Rear RH side door courtesy light switch signal / ON or OFF
ON: Rear RH side door open
OFF: Rear RH side door closed
-
RL Door Courtesy SW*1
Rear LH side door courtesy light switch signal / ON or OFF
ON: Rear LH side door open
OFF: Rear LH side door closed
-
Back Door Courtesy SW
Back door courtesy light switch signal / ON or OFF
ON: Back door open
OFF: Back door closed
-
Back Door Lock Pos SW
Back door lock position switch status / ON or OFF
ON: Back door unlocked
OFF: Back door locked
-
Glass Hatch Courtesy Switch*2
Glass hatch courtesy switch signal / ON or OFF
ON: Glass hatch open
OFF: Glass hatch closed
-
Glass Hatch Opener Switch*2
Glass hatch opener switch signal / ON or OFF
ON: Glass hatch opener switch pushed
OFF: Glass hatch opener switch not pushed
-
Door Key SW-Lock
Door key linked lock switch signal / ON or OFF
ON: Driver side door key cylinder turned to lock position
OFF: Driver side door key cylinder not turned
-
D-Door Key SW-UL
Door key linked unlock switch signal / ON or OFF
ON: Driver side door key cylinder turned to unlock position
OFF: Driver side door key cylinder not turned
-
FR Door Lock Pos
Front RH side door lock position switch signal / UNLOCK or LOCK
UNLOCK: Front RH side door unlocked
LOCK: Front RH side door locked
-
FR Door Courtesy
Front RH side door courtesy light switch signal / ON or OFF
OFF: Front RH side door closed
ON: Front RH side door open
-
FL Door Lock Pos
Front LH side door lock position switch signal / UNLOCK or LOCK
UNLOCK: Front LH side door unlocked
LOCK: Front LH side door locked
-
FL Door Courtesy
Front LH side door courtesy light switch signal / ON or OFF
OFF: Front LH side door closed
ON: Front LH side door open
-
Hood Courtesy SW
Security courtesy switch / ON or OFF
ON: Engine hood open
OFF: Engine hood closed
-
RR-Door Lock Pos SW*1
Rear RH side door lock position switch signal / ON or OFF
ON: Rear RH side door unlocked
OFF: Rear RH side door locked
-
RL-Door Lock Pos SW*1
Rear LH side door lock position switch signal / ON or OFF
ON: Rear LH side door unlocked
OFF: Rear LH side door locked
-
Intrusion Sens OFF SW*3
Intrusion sensor OFF switch / ON or OFF
ON: Intrusion sensor OFF switch pushed
OFF: Intrusion sensor OFF switch not pushed
-
Intrusion Sensor*3
Intrusion sensor detection / ON or OFF
ON: Moving object detected by sensor
OFF: No moving object detected by sensor
-
Tilt Sensor*4
Tilt sensor detection / ON or OFF
ON: Vehicle tilt detected by sensor
OFF: Vehicle tilt not detected by sensor
-
Intrusion Sen Conn*3
Intrusion sensor connecting / ON or OFF
ON: Intrusion sensor connected
OFF: Intrusion sensor not connected
-
Tilt Sensor Connect*4
Tilt sensor connecting / ON or OFF
ON: Tilt sensor connected
OFF: Tilt sensor not connected
-
Sealed Glas Brak Sen*5
Glass breakage sensor detection / With or Without
With: Glass breakage sensor operating
Without: Glass breakage sensor not operating
-
The Number of DTC
Number of trouble codes / Min.: 0, Max.: 255
Number of stored DTCs displayed
-
- *1: for 5 Door
- *2: w/ Glass Hatch Opener System
- *3: w/ Intrusion Sensor
- *4: w/ Tilt Sensor
- *5: w/ Glass Breakage Sensor
- *1: for 5 Door
| ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Active Test.
According to the display on the intelligent tester, perform the Active Test.
Main Body Tester Display
Test Part
Control Range
Diagnostic Note
Security Indicator
Security indicator
ON/OFF
The test is possible when the following conditions are met: - The key is in the cabin*1
- The engine switch on (IG)*1
- The key is in the ignition key cylinder*2
Security Horn2*3
Theft warning siren (self power siren)
ON/OFF
-
Vehicle Horn
Vehicle horns
ON/OFF
-
Security Horn*4
Security Horn
ON/OFF
-
Power For Intrusion Sensor*5
Intrusion sensor power supply
ON/OFF
-
Power For Tilt Sensor*6
Tilt sensor power supply
ON/OFF
-
- *1: w/ Entry and Start System
- *2: w/o Entry and Start System
- *3: w/ Security Siren
- *4: w/ Security Horn
- *5: w/ Intrusion Sensor
- *6: w/ Tilt Sensor
- The key is in the cabin*1