Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.
REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
Detach the 2 clips and remove the front door lower frame bracket garnish LH.
2.
REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH
Using a moulding remover, detach the 3 claws and remove the inside handle bezel as shown in the illustration.
3.
REMOVE ASSIST GRIP COVER LH
Using moulding remover A, detach the 8 claws and remove the assist grip cover.
4.
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
Remove the 3 screws.
Remove the 12 clips.
Pull out the front door trim board sub-assembly in the direction indicated by the arrow in the illustration.
Text in Illustration
*1
Reference Boss
Raise the front door trim board sub-assembly to detach the 4 claws and remove the front door trim board sub-assembly together with the front door inner glass weatherstrip LH.
Disconnect the 2 connectors.
w/ Seat Position Memory System:
Disconnect the connectors.
Disconnect the front door lock remote control cable assembly and front door inside locking cable assembly.
5.
REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
Using a screwdriver, detach the 4 claws and remove the front door inner glass weatherstrip from the front door trim board sub-assembly as shown in the illustration.
6.
REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
Disconnect the connector.
Remove the 3 nuts.
Detach the claw and remove the outer rear view mirror.