2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INITIALIZATION

Troubleshooting · Vehicles built from Aug 2013


RESET MEMORY

NOTICE:
  1. Perform Reset Memory (AT initialization) when replacing the automatic transmission assembly, valve body assembly or any of the shift solenoid valves.
  2. Reset Memory can be performed only with the intelligent tester.

HINT:
The TCM memorizes the control conditions of the automatic transmission assembly and engine assembly. Therefore, when the automatic transmission assembly, valve body assembly or any of the shift solenoid valves has been replaced, it is necessary to reset the memory so that the TCM can memorize the new information.
The reset procedure is as follows.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Powertrain / ECT / Utility / Reset Memory.

    NOTICE:
    After performing Reset Memory, be sure to perform the Road Test (Click here) described earlier.

    HINT:
    The TCM learns through the road test.

← MANUAL SHIFTING TEST (from Aug 2014)MONITOR DRIVE PATTERN (Aug 2013 – Jul 2014) →