2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INITIALIZATION

Troubleshooting · Vehicles built from Aug 2013


RESET MEMORY

NOTICE:
  1. Perform Reset Memory (AT initialization) when replacing the automatic transmission assembly, valve body assembly or any of the shift solenoid valves.
  2. Reset Memory can only be performed with the GTS.

HINT:
The ECM memorizes the control conditions of the automatic transmission assembly and engine assembly. Therefore, when the automatic transmission assembly, valve body assembly or any of the shift solenoid valves has been replaced, it is necessary to reset the memory so that the ECM can memorize the new information.
The reset procedure is as follows.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Powertrain / Engine and ECT / Utility / Reset Memory.

    NOTICE:
    After performing Reset Memory, be sure to perform the Road Test (Click here) described earlier.

    HINT:
    The ECM learns through the Road Test.


ATF THERMAL DEGRADATION ESTIMATE RESET

NOTICE:
If either of the following conditions is met, perform ATF Thermal Degradation Estimate Reset.

  1. The ATF has been replaced.
  2. Approximately 50% or more of the ATF has been replaced during a repair of the transmission or a similar operation.
  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

    NOTICE:
    Do not start the engine.

  3. Turn the GTS on.

  4. Enter the following menus: Powertrain / Engine and ECT / Utility / ATF Thermal Degradation Estimate Reset.

← MANUAL SHIFTING TEST (from Aug 2014)MONITOR DRIVE PATTERN (Aug 2013 – Jul 2014) →