2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

TERMINALS OF ECU

System information · Vehicles built from Aug 2013


CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
E132743E15
  1. Disconnect the G25 amplifier connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    G25-21 (B) - G25-14 (GND)
    V - W-B
    Battery power source
    Always
    11 to 14 V
    G25-1 (IG+) - G25-14 (GND)
    L - W-B
    Ignition power supply
    Ignition switch ON
    11 to 14 V
    G25-1 (IG+) - G25-14 (GND)
    L - W-B
    Ignition power supply
    Ignition switch off
    Below 1 V
    G25-14 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    1. If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the G25 air conditioning amplifier connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    G25-38 (RDFG) - G25-14 (GND)
    P - W-B
    Rear defogger signal
    Ignition switch ON, rear window defogger switch off
    11 to 14 V
    G25-38 (RDFG) - G25-14 (GND)
    P - W-B
    Rear defogger signal
    Ignition switch ON, rear window defogger switch on
    Below 1 V
    1. If the result is not as specified, there may be a malfunction in the air conditioning amplifier.


CHECK INTEGRATION CONTROL AND PANEL ASSEMBLY
E196915E06
  1. Disconnect the G23 air conditioning control connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    G23-1 (+B) - G23-4 (GND)
    L - W-B
    Battery power source
    Always
    11 to 14 V
    G23-5 (IG) - G23-4 (GND)
    L - W-B
    IG power supply
    Ignition switch ON
    11 to 14 V
    G23-6 (ACC) - G23-4 (GND)
    P - W-B
    ACC power supply
    Ignition switch ACC
    11 to 14 V
    G23-4 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    1. If the result is not as specified, there may be a malfunction in the wire harness.

← PROBLEM SYMPTOMS TABLE (from Aug 2014)DATA LIST / ACTIVE TEST (from Aug 2013) →