2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

Air Conditioning Cut Control Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit cuts air conditioning operation during vehicle acceleration in order to increase acceleration performance. During acceleration with the vehicle speed at 30 km/h (19 mph) or less and the accelerator pedal opening angle at 45° or more, the A/C magnetic switch is turned off for several seconds.
The air conditioning is also controlled using the engine coolant temperature output from the ECM to the A/C amplifier.

WIRING DIAGRAM

A227852E04

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (CHECK OPERATION OF AIR CONDITIONING CUT CONTROL)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine and turn the air conditioning switch on.

    HINT:
    The A/C magnetic clutch is turned on.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / A/C Cut SIG.

  1. Check operation of the A/C magnetic clutch cut when air conditioning cut control is operated by the intelligent tester.

    OK:
    A/C magnetic clutch is turned off.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT ECM (ACT VOLTAGE)

  1. A227853E02
    Start the engine.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    G62-8 (ACT) - Body ground
    Engine idling
    11 to 14 V
    G62-8 (ACT) - Body ground
    Ignition switch ON, engine stopped
    0 to 3 V

    Text in Illustration 
    *a
    Component with harness connected
    (ECM)



NG
Go to step 3
OK

REPLACE ECM (Click here)

3. CHECK HARNESS AND CONNECTOR (ECM - AIR CONDITIONING AMPLIFIER)
  1. Disconnect the A/C amplifier connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Open):
    Tester Connection
    Condition
    Specified Condition
    G25-27 (ACT) - G62-8 (ACT)
    Always
    Below 1 Ω

    Standard Resistance (Check for Short):
    Tester Connection
    Condition
    Specified Condition
    G25-27 (ACT) or G62-8 (ACT) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the A/C amplifier connector.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER (Click here)


← Air Conditioning Signal Circuit (from Aug 2014)Air Conditioning Cut Control Circuit (from Aug 2014) →