2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use these procedures to troubleshoot the airbag system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK CAN COMMUNICATION SYSTEM*
    1. Check if a CAN communication system DTC is output.

      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output (for LHD with Entry and Start System)
      B
      DTC is output (for LHD without Entry and Start System)
      C
      DTC is output (for RHD with Entry and Start System)
      D
      DTC is output (for RHD without Entry and Start System)
      E


    B.

    C.

    D.

    E.
    A

    4.WARNING LIGHT CHECK
      NEXT

      5.CHECK DTC (Present and Past DTCs)*
      1. Check for DTCs (Click here).

        Result 
        Result
        Proceed to
        DTC is output
        A
        DTC is not output
        B


      B.
      A

      6.DTC CHART
        NEXT

        7.CIRCUIT INSPECTION
          NEXT

          8.REPAIR
            NEXT

            9.CLEAR DTC (Present and Past DTCs)*
              NEXT

              10.CHECK DTC (Present and Past DTCs)*
              1. Check for DTCs (Click here).

                Result 
                Result
                Proceed to
                DTC is not output
                A
                DTC is output
                B


              B.
              A

              11.CONFIRMATION TEST
                NEXT

                ← SYSTEM DESCRIPTION (from Aug 2013)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2014) →