Troubleshooting · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
HINT:
The vehicle stability control system troubleshooting procedures are based on the premise that the CAN communication system is functioning normally. Check the CAN communication system first before troubleshooting the vehicle stability control system.
*: Use the intelligent tester.
1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.CUSTOMER PROBLEM ANALYSIS
Interview the customer and confirm the trouble.
HINT:
Interview the customer to confirm the following:
History of brake fluid replacement.
Whether the engine was stopped intentionally when driving.
Whether the brake and accelerator pedals were depressed simultaneously.
NEXT
3.INSPECT BATTERY VOLTAGE
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
NEXT
4.CHECK DTC AND FREEZE FRAME DATA*
Check and record output DTCs and the freeze frame data.
Clear the DTCs and freeze frame data (Click here for DTC Check/Clear, or Click here for Freeze Frame Data).
Reconfirm the DTCs.
Reconfirm the DTCs based on the recorded output DTCs and freeze frame data (Click here for DTC Check/Clear, or Click here for Freeze Frame Data).
HINT:
If DTC U0073, U0100, U0114, U0123, U0124 or U0126 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit (Click here).
Result
Result
Proceed to
DTC output
A
DTC not output (Problem symptom does not occur)
B
DTC not output (Problem symptom occurs)
C
B.
C.
A
5.DIAGNOSTIC TROUBLE CODE CHART
Proceed to Diagnostic Trouble Code Chart (Click here).
NEXT
6.SYMPTOM SIMULATION
Proceed to Check for Intermittent Problems (Click here).