C1427 Motor Malfunction
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1427 |
The actuator pump motor does not operate properly. |
|
WIRING DIAGRAM
Refer to DTCs C0273, C0274 and C1361 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform calibration (Click here).
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MOTOR RELAY) |
Turn the ignition switch off
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
ABS/VSC/TRC Tester Display
Test Part
Control Range
Diagnostic Note
Motor Relay
Motor relay
Relay ON / OFF
The operating sound of the motor can be heard.
Check for the operating sound of the motor relay when operating it with the intelligent tester.
Result Result
Proceed to
Operating sound is not heard
A
Operating sound is heard
B
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (GND2 TERMINAL) |
Disconnect the A6 skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A6-13 (GND2) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. RECONFIRM DTC |
- HINT:
- This code is stored when a problem is identified in the brake actuator assembly.
- The motor relay is in the brake actuator assembly.
- Therefore, motor relay unit inspections cannot be performed. Be sure to check if the DTC is output before replacing the brake actuator assembly.
Turn the ignition switch off.
Reconnect the skid control ECU connector.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
B
- HINT:
- If a speed signal of 6 km/h (4 mph) or more is input to the skid control ECU with the ignition switch ON and the stop light switch off, the ECU performs self-diagnosis of the motor and solenoid circuits.
- If the normal system code is output (no trouble codes are output), slightly jiggle the connectors, wire harnesses, and fuses of the brake actuator assembly. Make sure that no DTCs are output.
- If any DTCs are output while jiggling a connector or wire harness of the brake actuator assembly (skid control ECU), inspect and repair the connector or wire harness. The DTCs were probably output due to a bad connection of the connector terminal.
- If a speed signal of 6 km/h (4 mph) or more is input to the skid control ECU with the ignition switch ON and the stop light switch off, the ECU performs self-diagnosis of the motor and solenoid circuits.
|
|
||||
| A | ||
| ||
