2013-2015 Land Cruiser Prado · Service Manual Suspension

TERMINALS OF ECU

System information · Vehicles built from Aug 2013


CHECK TIRE PRESSURE WARNING ECU AND RECEIVER

  1. Disconnect the tire pressure warning ECU and receiver R41 connector and measure the voltage or resistance on the wire harness side.
    C279757E01

    Text in Illustration  
    *a
    Front view of wire harness connector
    (to Tire Pressure Warning ECU and Receiver)
    -
    -
    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R41-1 (IG) - R41-12 (GND)
    G - BR
    IG power source
    Ignition switch ON
    10 to 16 V
    R41-12 (GND) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω

  2. Connect the tire pressure warning ECU and receiver R41 connector.

  3. Measure the voltage according to the value(s) in the table below. If the result is not as specified, the ECU may have a malfunction.

    HINT:
    Inspect the connectors from the back side while the connectors are connected.

    E129452E70
    Text in Illustration  
    *a
    Component with harness connected
    (Tire Pressure Warning ECU and Receiver)
    -
    -
    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R41-7 (CLSW) - R41-12 (GND))
    P - BR
    Tire pressure warning reset switch
    1. Ignition switch ON
    2. Tire pressure warning reset switch ON
    Below 2.4 V
    1. Ignition switch ON
    2. Tire pressure warning reset switch OFF
    8 to 15 V

← PROBLEM SYMPTOMS TABLE (from Aug 2014)DIAGNOSIS SYSTEM (Aug 2013 – Jul 2014) →