Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
DESCRIPTION
This is the power source for the tire pressure warning ECU and receiver.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
1. CHECK HARNESS AND CONNECTOR (ECU - BATTERY)
Disconnect the tire pressure warning ECU and receiver R41 connector.
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
R41-1 (IG) - Body ground
Ignition switch ON
10 to 16 V
Ignition switch off
Below 1 V
Text in Illustration
*a
Front view of wire harness connector (to Tire Pressure Warning ECU and Receiver)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
2. CHECK HARNESS AND CONNECTOR (ECU - BODY GROUND)
Disconnect the tire pressure warning ECU and receiver R41 connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
R41-12 (GND) - Body ground
Always
Below 1 Ω
Text in Illustration
*a
Front view of wire harness connector (to Tire Pressure Warning ECU and Receiver)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER (Click here)