DATA LIST / ACTIVE TEST
System information · Vehicles built from Aug 2013
| READ DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Data List.
According to the display on the intelligent tester, read the Data List.
Entry&Start Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
D-Door Touch Sensor
Driver side door unlock sensor / ON or OFF
ON: Driver side door unlock sensor touched
OFF: Driver side door unlock sensor not touched
-
P-Door Touch Sensor
Front passenger side door unlock sensor / ON or OFF
ON: Front passenger side door unlock sensor touched
OFF: Front passenger side door unlock sensor not touched
-
D-Door Trigger Switch
Driver side door lock sensor / ON or OFF
ON: Driver side door lock sensor touched
OFF: Driver side door lock sensor not touched
-
P-Door Trigger Switch
Front passenger side door lock sensor / ON or OFF
ON: Front passenger side door lock sensor touched
OFF: Front passenger side door lock sensor not touched
-
Tr/B-Door Lock SW
Back door lock switch / ON or OFF
ON: Back door lock switch pushed
OFF: Back door lock switch not pushed
-
Tr/B-Door Unlock SW
Back door unlock switch / ON or OFF
ON: Back door unlock switch pushed
OFF: Back door unlock switch not pushed
-
Ignition Switch
Engine switch on (IG) / ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
Unmatched Vehicle-ID
No communication condition between vehicle and electrical key transmitter (vehicle-ID) / Yes or No
Yes: Key ID code not matched to vehicle
No: Key ID code matched to vehicle
-
No Response
No communication condition between vehicle and electrical key transmitter (response) / Yes or No
Yes: Key ID code not matched to vehicle
No: Key ID code matched to vehicle
-
Unmatch Code or Form
No communication condition between vehicle and electrical key transmitter (response code and format) / Yes or No
Yes: Key ID code not matched to vehicle
No: Key ID code matched to vehicle
-
Key Low Battery
Key low battery / Yes or No
Yes: Key battery voltage low
No: Key battery voltage normal
-
Power Save Cnt 10 Min
Power save counter - 10 minutes / Min: 0, Max: 225
Within range of 0 to 225
-
Power Save Cnt 5 Days
Power save counter - 5 days / Min: 0, Max: 225
Within range of 0 to 225
-
Power Save Cnt 14 Days
Power save counter - 14 days / Min: 0, Max: 225
Within range of 0 to 225
-
ID Code Difference(Resp)
No communication condition between vehicle and electrical key transmitter (ID code) / Yes or No
Yes: Key ID code not matched to vehicle
No: Key ID code matched to vehicle
-
C Code Difference
No communication condition between vehicle and electrical key transmitter (challenge code) / Yes or No
Yes: Key ID code not matched to vehicle
No: Key ID code matched to vehicle
-
Auto Entry Cancel SW
Entry door lock function cancel / ON or OFF
Mode status displayed
-
Door Unlock Mode2
Door unlock mode / All or Driver
Mode status displayed
-
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
ACC SW
Engine switch on (ACC) / ON or OFF
ON: Engine switch on (ACC)
OFF: Engine switch off
-
IG SW
Engine switch on (IG) / ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
RR Door Courtesy SW*1
Rear RH side door courtesy light switch signal / ON or OFF
ON: Rear RH side door open
OFF: Rear RH side door closed
-
RL Door Courtesy SW*1
Rear LH side door courtesy light switch signal / ON or OFF
ON: Rear LH side door open
OFF: Rear LH side door closed
-
Back Door Courtesy SW
Back door courtesy light switch signal / ON or OFF
ON: Back door open
OFF: Back door closed
-
Back Door Lock Pos SW
Back door lock position switch status / ON or OFF
ON: Back door unlocked
OFF: Back door locked
-
Glass Hatch Courtesy Switch*2
Glass hatch courtesy switch signal / ON or OFF
ON: Glass hatch open
OFF: Glass hatch closed
-
Glass Hatch Opener Switch*2
Glass hatch opener switch signal / ON or OFF
ON: Glass hatch opener switch pushed
OFF: Glass hatch opener switch not pushed
-
FR Door Lock Pos
Front RH side door lock position switch signal / UNLOCK or LOCK
UNLOCK: Front RH side door unlocked
LOCK: Front RH side door locked
-
FR Door Courtesy
Front RH side door courtesy light switch signal / ON or OFF
OFF: Front RH side door closed
ON: Front RH side door open
-
FL Door Lock Pos
Front LH side door lock position switch signal / UNLOCK or LOCK
UNLOCK: Front LH side door unlocked
LOCK: Front LH side door locked
-
FL Door Courtesy
Front LH side door courtesy light switch signal / ON or OFF
OFF: Front LH side door closed
ON: Front LH side door open
-
RR-Door Lock Pos SW*1
Rear RH side door lock position switch signal / ON or OFF
ON: Rear RH side door unlocked
OFF: Rear RH side door locked
-
RL-Door Lock Pos SW*1
Rear LH side door lock position switch signal / ON or OFF
ON: Rear LH side door unlocked
OFF: Rear LH side door locked
-
- *1: for 5 Door
- *2: w/ Glass Hatch Opener System
- *1: for 5 Door
| PERFORM ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry&Start / Active Test.
According to the display on the intelligent tester, perform the Active Test.
Entry&Start Tester Display
Test Part
Control Range
Diagnostic Note
Overhead Tuner Power Supply ON
Door control receiver
ON/OFF
-
Power for P-Seat Sens
Front door outside handle (for front passenger side)
ON/OFF
-