2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. REMOVE UPPER RADIATOR SUPPORT SEAL
  1. Remove the 13 clips and upper radiator support seal.


2. REMOVE RADIATOR GRILLE

B357908E01
  1. Put protective tape around the radiator grille.

  1. Remove the 4 screws.

  1. Detach the 8 claws and remove the radiator grille.

    Text in Illustration 
    *1
    Protective Tape


3. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

B348963
  1. Disconnect the sensor connector.

  1. Remove the 3 bolts and millimeter wave radar sensor assembly.


4. REMOVE HOOD LOCK RELEASE LEVER PROTECTOR

  1. B358781E01
    Detach the 2 clamps, 2 guides and remove the hood lock release lever protector.
    Text in Illustration 
    *a
    Clamp
    *b
    Guide


5. REMOVE HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)

  1. B358782
    Remove the 3 bolts.

  1. B358783
    Disconnect the connector.

  1. Disconnect the hood lock control cable assembly and remove the hood lock assembly (engine hood courtesy switch).

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →