2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

Jam Protection Function does not Operate

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

  1. This problem may occur in all door windows.
    The jam protection function operates within a specified range during the manual up or auto up operation.

INSPECTION PROCEDURE


1. PERFORM INITIALIZATION
  1. Initialize the power window regulator motor (Click here).

  1. Check if the power window auto up/down function operates (Click here).

    OK:
    Auto up/down function operates.



NG
END (PROBLEM DUE TO INITIALIZATION FAILURE)
OK


2. CHECK JAM PROTECTION FUNCTION OPERATING RANGE
  1. Check if the jam protection function operates for applicable power window.

    HINT:
    The jam protection function does not operate between the fully closed position of the door glass and the position 4 mm (0.157 in.) below that.

    OK:
    Jam protection function operates.
    Result 
    Result
    Proceed to
    OK
    A
    NG (Front power window LH)
    B
    NG (Front power window RH)
    C
    NG (Rear power window LH)*
    D
    NG (Rear power window RH)*
    E

    1. *: for 5 Door



B
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (Click here)

C
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (Click here)

D
REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (Click here)

E
REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (Click here)
A

END


← Jam Protection Function does not Operate (Aug 2013 – Jul 2014)COMPONENTS (from Aug 2013) →