2013-2015 Land Cruiser Prado · Service Manual Brake

C1290 Steering Angle Sensor Zero Point Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2013

DESCRIPTION

The skid control ECU acquires steering angle sensor zero point every time the ignition switch is turned to ON and the vehicle is driven at 40 km/h (25 mph) or more for approximately 10 seconds. The ECU also stores the previous zero point.
If the front wheel alignment or steering wheel position is adjusted without disconnecting the cable from the negative (-) battery terminal, or if the yaw rate and acceleration sensor zero point is not acquired after the adjustments have been completed, the skid control ECU detects the difference between the previous zero point and newly acquired zero point and stores this DTC to indicate a poor adjustment.
The steering angle sensor zero point malfunction warning is canceled by turning the ignition switch off.
DTC Code
DTC Detection Condition
Trouble Area
C1290
The steering angle sensor zero point calibration position vastly differs from the recorded value.
  1. Yaw rate and acceleration sensor zero point calibration incomplete
  2. Poor adjustment of centered position of steering wheel
  3. Poor adjustment of front wheel alignment

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform calibration (Click here).


1. PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR
  1. Perform zero point calibration of the yaw rate and acceleration sensor (Click here).

    HINT:
    1. When the stored zero point of the yaw rate and acceleration sensor is cleared, the steering angle sensor zero point is also cleared.
    2. If the zero point and output value of the yaw rate and acceleration sensor and the output value of the speed sensors are not normal, steering angle sensor zero point cannot be acquired normally even if the vehicle is driven straight ahead at 40 km/h (25 mph) or more.


NEXT


2. CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION
  1. Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds.

  1. Check that the centered position of the steering wheel is correctly set while driving straight ahead.

    HINT:
    If the front wheel alignment and steering position are adjusted as a result of an abnormal centered position of the steering wheel, acquire the yaw rate and acceleration sensor zero point again after the adjustments are completed.

    OK:
    The centered position of the steering wheel is correctly set.



NG
ADJUST FRONT WHEEL ALIGNMENT OR STEERING POSITION
OK

END


← C1282 Center Differential Lock Position Switch (from Aug 2014)C1337 Diameter of the Tire is not Uniform (Aug 2013 – Jul 2014) →