INSTALLATION
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. INSTALL VACUUM PUMP ASSEMBLY |
Install 2 new O-rings.
Install the pump to the engine with the 2 nuts.
- Torque:
- 21 N*m{ 214 kgf*cm , 15 ft.*lbf }
Connect the 2 hoses to the pump with the clip.
| 2. INSTALL RADIATOR ASSEMBLY |
Install the radiator assembly (Click here).
| 3. CHECK VACUUM PUMP ASSEMBLY |
![]() ![]() |
Disconnect the vacuum hose from the vacuum pump.
Connect the hose of a vacuum gauge to the pump.
Text in Illustration *1
Vacuum Gauge
*2
Plug
Insert a plug into the other hose of the gauge.
Start the engine and warm it up for more than 2 minutes.
With the engine idling, measure the negative pressure of the pump.
- Standard negative pressure:
- More than 86.7 kPa (650 mmHg, 26 in.Hg)
- HINT:
- the vacuum pump assembly is listed as on of the 200000 km (124000 mile) maintenance parts. Make sure to disassemble and inspect it every 200000 km (124000 miles) and replace parts as necessary.
Remove the gauge from the pump.
Connect the hose to the pump with the clip.


