2013-2015 Land Cruiser Prado · Service Manual Brake

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE CHECK VALVE SUB-ASSEMBLY

C111343
  1. Mount the pump in a vise.

    NOTICE:
    Place aluminum plates on the vise to prevent damage to the pump.

  1. Remove the union bolt, union and 2 gaskets.

  1. C111344
    Remove the check valve and gasket.


2. REMOVE VACUUM PUMP END COVER

C111345
  1. Remove the 3 bolts.

  1. C111346
    Using a 5 mm pin punch and hammer, tap out the 2 straight pins.

  1. Remove the end cover and 2 O-rings.


3. REMOVE VACUUM PUMP ROTOR SUB-ASSEMBLY

C111347
  1. Remove the rotor together with the 5 blades.

    NOTICE:
    Be careful not to drop the blades.


4. REMOVE VACUUM PUMP BLADE
  1. Remove the 5 blades from the rotor.


5. REMOVE VACUUM PUMP GEAR

C111348
  1. Mount the gear in a vise.

    NOTICE:
    Place aluminum plates on the vise to prevent damage to the gear.

  1. Remove the gear lock nut.

  1. Remove the gear and woodruff key.


6. REMOVE VACUUM PUMP SHAFT

C111349
  1. Using snap ring pliers, remove the snap ring.

  1. C111350
    Using a plastic-faced hammer, tap out the shaft.


7. REMOVE VACUUM PUMP BEARING

C111351
  1. Using a 17 mm socket wrench and press, press out the bearing.

← REMOVAL (from Aug 2014)INSPECTION (from Aug 2013) →