2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the following procedure to troubleshoot the navigation system.
  2. *: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      1. When troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
      3. The following 5 items are important points in problem analysis:
        What
        Vehicle model, system name
        When
        Date, time, occurrence frequency
        Where
        Road conditions
        Under what conditions?
        Driving conditions, weather conditions
        How did it happen?
        Problem symptoms
    NEXT

    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard voltage:
      11 to 14 V

      HINT:
      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT

    4.CHECK CABIN
    1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

      OK:
      Condensation is not likely being produced and the temperature is not high or extremely low.

      HINT:
      1. A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
      2. The navigation system may not operate normally when the temperature is -20°C (-4°F) or less, or 65°C (149°F) or higher.


    NG.
    OK

    5.CHECK VEHICLE CONDITION
    1. Check the vehicle condition.

      Result 
      Result
      Proceed to
      except Pioneer Made
      A
      for Pioneer Made
      B


    B.
    A

    6.CHECK NAVIGATION SYSTEM NORMAL CONDITION
    1. Refer to Check Navigation System Normal Condition (Click here).

      Result 
      Result
      Proceed to
      Symptom is not normal operation.
      A
      Symptom is normal operation.
      B


    B.
    A

    7.CHECK CAN COMMUNICATION SYSTEM*
    1. Check if CAN communication system DTCs are output.for LHD: Click here for RHD: Click here

      Result 
      Result
      Proceed to
      CAN DTCs are not output.
      A
      CAN DTCs are output. (for LHD)
      B
      CAN DTCs are output. (for RHD)
      C


    B.

    C.
    A

    8.CHECK FOR DTC*
    1. Refer to DTC Check/Clear (Click here).

      Result 
      Result
      Proceed to
      DTCs are output.
      A
      DTCs are not output.
      B


    B.
    A

    9.DTC CLEAR*
    1. Refer to DTC Check/Clear (Click here).

      HINT:
      The present DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.

    NEXT

    10.RECHECK FOR DTC*
    1. Refer to DTC Check/Clear (Click here).

      Result 
      Result
      Proceed to
      DTCs are output.
      A
      DTCs are not output.
      B

      HINT:
      1. Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.
      2. Check the DTCs and inspect the area that the code indicates.


    B.
    A

    11.DIAGNOSTIC TROUBLE CODE CHART
      1. *1: w/ Rear Seat Entertainment System
      2. *2: w/ Parking Assist Monitor System (w/ Side Monitor System)
      3. *3: w/ Parking Assist Monitor System (w/o Side Monitor System)
      4. *4: w/ Wide View Front Monitor System
      5. *5: w/ Side Monitor System
      6. *6: w/ Rear View Monitor System (for Navigation Receiver Type)
    1. Find the output code in Diagnostic Trouble Code Chart (Click here).

      NOTICE:
      1. The navigation system outputs DTCs for the following system.
      2. When DTCs other than those in Diagnostic Trouble Code Chart for the navigation system are output, refer to Diagnostic Trouble Code Chart for the relevant system.
      3. Refer to Rear Seat Entertainment System (Click here)*1
      4. Refer to Parking Assist Monitor System (w/ Side Monitor) (Click here)*2
      5. Refer to Parking Assist Monitor System (w/ Side Monitor) (Click here)*3
      6. Refer to Wide View Front Monitor System (Click here)*4
      7. Refer to Side Monitor System (Click here)*5
      8. Refer to Rear View Monitor System (for Navigation Receiver Type) (Click here)*6

      Result 
      Result
      Proceed to
      DTCs for the rear seat entertainment system are output.*1
      A
      DTCs for the parking assist monitor system (w/ Side Monitor System) are output.*2
      B
      DTCs for the parking assist monitor system (w/o Side Monitor System) are output.*3
      C
      DTCs for the wide view front monitor system are output.*4
      D
      DTCs for the side monitor system are output.*5
      E
      DTCs for the rear view monitor system (for Navigation Receiver Type) are output.*6
      F
      DTCs for the navigation system are output.
      G


    B.

    C.

    D.

    E.

    F.

    G.
    A

    12.CHECK SD CARD
    1. Enter the "SD Check" screen. Refer to Check SD Card in Operation Check (Click here).

      Result 
      Result
      Proceed to
      "OK" is displayed.
      A
      "NG" is displayed.
      B


    B.
    A

    13.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table.
      A
      Fault is listed in Problem Symptoms Table.
      B

      HINT:
      If the symptom does not recur and no DTCs are output, attempt to reproduce the symptoms (Click here).


    B.
    A

    14.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM
    1. Refer to Terminals of ECU (Click here).

    NEXT

    15.CHECK CIRCUIT
    1. Adjust, repair or replace as necessary.

    NEXT

    16.RECHECK FOR DTC
    1. After clearing DTCs, recheck for DTCs (Click here).

    NEXT

    17.PERFORM CONFIRMATION TEST
      NEXT

      18.CHECK SD CARD
      1. Check that the navigation screen is displayed when the "HOME" switch is pressed (Click here).

        Result 
        Result
        Proceed to
        The navigation screen is displayed.
        A
        The navigation screen is not displayed, a warning message is displayed, and the navigation system continues to operate in audio mode.
        B
        The navigation system does not respond when the "HOME" switch is pressed.
        C


      B.

      C.
      A

      19.CHECK NAVIGATION SYSTEM NORMAL CONDITION
      1. Refer to Check Navigation System Normal Condition (Click here).

        Result 
        Result
        Proceed to
        Symptom is not normal operation.
        A
        Symptom is normal operation.
        B


      B.
      A

      20.CHECK CAN COMMUNICATION SYSTEM*
      1. Check if CAN communication system DTCs are output.for LHD: Click here for RHD: Click here

        Result 
        Result
        Proceed to
        CAN DTCs are not output.
        A
        CAN DTCs are output. (for LHD)
        B
        CAN DTCs are output. (for RHD)
        C


      B.

      C.
      A

      21.CHECK FOR DTC*
      1. Refer to DTC Check/Clear (Click here).

        Result 
        Result
        Proceed to
        DTCs are output.
        A
        DTCs are not output.
        B


      B.
      A

      22.DTC CLEAR*
      1. Refer to DTC Check/Clear (Click here).

        HINT:
        The present DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.

      NEXT

      23.RECHECK FOR DTC*
      1. Refer to DTC Check/Clear (Click here).

        Result 
        Result
        Proceed to
        DTCs are output.
        A
        DTCs are not output.
        B

        HINT:
        1. Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.
        2. Check the DTCs and inspect the area that the code indicates.


      B.
      A

      24.DIAGNOSTIC TROUBLE CODE CHART
        1. *1: w/ Rear Seat Entertainment System
        2. *2: w/ Parking Assist Monitor System (w/ Side Monitor System)
        3. *3: w/ Parking Assist Monitor System (w/o Side Monitor System)
        4. *4: w/ Wide View Front Monitor System
        5. *5: w/ Side Monitor System
        6. *6: w/ Rear View Monitor System (for Navigation Receiver Type)
      1. Find the output code in Diagnostic Trouble Code Chart (Click here).

        NOTICE:
        1. The navigation system outputs DTCs for the following system.
        2. When DTCs other than those in Diagnostic Trouble Code Chart for the navigation system are output, refer to Diagnostic Trouble Code Chart for the relevant system.
        3. Refer to Rear Seat Entertainment System (Click here)*1
        4. Refer to Parking Assist Monitor System (w/ Side Monitor) (Click here)*2
        5. Refer to Parking Assist Monitor System (w/o Side Monitor) (Click here)*3
        6. Refer to Wide View Front Monitor System (Click here)*4
        7. Refer to Side Monitor System (Click here)*5
        8. Refer to Rear View Monitor System (for Navigation Receiver Type) (Click here)*6

        Result 
        Result
        Proceed to
        DTCs for the rear seat entertainment system are output.*1
        A
        DTCs for the parking assist monitor system (w/ Side Monitor System) are output.*2
        B
        DTCs for the parking assist monitor system (w/o Side Monitor System) are output.*3
        C
        DTCs for the wide view front monitor system are output.*4
        D
        DTCs for the side monitor system are output.*5
        E
        DTCs for the rear view monitor system (for Navigation Receiver Type) are output.*6
        F
        DTCs for the navigation system are output.
        G


      B.

      C.

      D.

      E.

      F.

      G.
      A

      25.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).

        Result 
        Result
        Proceed to
        Fault is not listed in Problem Symptoms Table.
        A
        Fault is listed in Problem Symptoms Table.
        B

        HINT:
        If the symptom does not recur and no DTCs are output, attempt to reproduce the symptoms (Click here).


      B.
      A

      26.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM
      1. Refer to Terminals of ECU (Click here).

      NEXT

      27.CHECK CIRCUIT
      1. Adjust, repair or replace as necessary.

      NEXT

      28.RECHECK FOR DTC
      1. After clearing DTCs, recheck for DTCs (Click here).

      NEXT

      29.PERFORM CONFIRMATION TEST
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2013 – Jul 2014)OPERATION CHECK (Aug 2013 – Jul 2014) →