2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REPLACEMENT

Removal / installation · Vehicles built from Aug 2013


1. REPLACE TIGHT PLUG

NOTICE:
If coolant leaks from the tight plug or the plug is corroded, replace it.


A118124E03
Text in Illustration 
*a
Right Side
*b
Rear Side
*c
Left Side
*d
Stops
  1. Apply adhesive to new tight plugs.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. Install the tight plugs as shown in the illustration.

  1. Using SST, tap in the 2 tight plugs labeled A.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

  1. Using SST, tap in the 4 tight plugs labeled B.

    SST
    09950-60010   (09951-00350)
    09950-70010   (09951-07100)

  1. Using SST, tap in the tight plug labeled C.

    SST
    09950-60010   (09951-00500)
    09950-70010   (09951-07100)


2. REPLACE STRAIGHT PIN

NOTICE:
It is not necessary to remove a straight pin unless it is being replaced.

  1. Install the straight pins as shown in the illustration.

    A071267E04

    Text in Illustration 
    *a
    Rear Side
    *b
    Until Pin Stops


3. REPLACE RING PIN

NOTICE:
It is not necessary to remove a ring pin unless it is being replaced.

  1. Install the ring pins as shown in the illustration.

    A071268E05

    Text in Illustration 
    *a
    Front Side
    *b
    Cylinder Head Side
    *c
    Rear Side
    *d
    Until Pin Stops


4. REPLACE CONNECTING ROD SMALL END BUSH

  1. A057244E02
    Using SST and a press, press out the bushing.
    SST
    09222-54011   (09222-03016, 09222-03026, 09222-03021)

  1. A056739E01
    Using a round file, lightly file off any roughness from the small end of the connecting rod.

  1. A057240E03
    Attach a new bush to SST with the ball of SST inside the oil hole of the bush.
    SST
    09222-54011   (09222-03021)
    Text in Illustration 
    *1
    Oil Hole
    *2
    Ball

  1. A056722E03
    Align the oil holes of the bush and connecting rod.
    Text in Illustration 
    *1
    Oil Hole

  1. A057245E03
    Using SST and a press, press in the bush.
    SST
    09222-54011   (09222-03016, 09222-03026, 09222-03021)
    Text in Illustration 
    *1
    Bush

  1. A057241E01
    Using a pin hole grinder, hone the bush to obtain the clearance between the bush and piston pin.

  1. Check the piston pin fit at normal room temperature.

    1. A057242E01
      Coat the piston pin with engine oil, and push it into the connecting rod with your thumb.

← INSPECTION (from Aug 2013)REASSEMBLY (from Aug 2013) →