Stereo Component Amplifier Power Source Circuit
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This circuit provides power to the stereo component amplifier assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - BATTERY AND BODY GROUND) |
Disconnect the stereo component amplifier assembly connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H67-3 (GND) - Body ground
Always
Below 1 Ω
H67-18 (GND2) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
H67-1 (+B) - Body ground
Always
11 to 14 V
H67-18 (+B2) - Body ground
Always
11 to 14 V
H63-12 (ACC) - Body ground
Ignition switch ACC
11 to 14 V
| *a |
Front view of wire harness connector (to Stereo Component Amplifier Assembly) |
|
|
||||
| OK | ||
| ||
