2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

ON-VEHICLE INSPECTION

Inspection · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


REMOVE WASHER RR RELAY

E202166E01
  1. Remove the washer RR relay from the engine room relay block.

    Text in Illustration 
    *1
    Washer RR Relay


INSPECT WASHER RR RELAY

B242124E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied between terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    1. If the result is not as specified, replace the washer RR relay.


INSTALL WASHER RR RELAY
  1. Install the washer RR relay to the engine room relay block.


CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← INSTALLATION (from Aug 2014)ON-VEHICLE INSPECTION (from Aug 2014) →