INSPECTION
Inspection · Vehicles built from Aug 2013
| INSPECT ENGINE COOLANT TEMPERATURE SENSOR |
Partially immerse the sensor in water and warm up the water.
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Approx. 20°C (68°F)
2.32 to 2.59 kΩ
1 - 2
Approx. 80°C (176°F)
0.310 to 0.326 kΩ
Text in Illustration *1
Resistance kΩ
*2
Temperature °C (°F)
*3
Acceptable
*a
Component without harness connected
(Engine Coolant Temperature Sensor)
- If the result is not as specified, replace the engine coolant temperature sensor.
- NOTICE:
- When checking the sensor in water, keep the terminals dry. After the check, wipe the sensor dry.
