2013-2015 Land Cruiser Prado · Service Manual Steering

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

NOTICE:
  1. When using a vise, do not overtighten it.
  2. When installing the parts indicated by arrows, coat them with power steering fluid (Click here).


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FAN AND GENERATOR V BELT

  1. A099194E01
    Use the hexagonal part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the V belt. Then remove the V belt.

    NOTICE:
    When removing the V belt, do not use the bolt of the idle pulley.

    HINT:
    After removing the drive belt, move the tensioner upward to the maximum amount.


3. DISCONNECT RETURN HOSE

  1. C215471
    Remove the clip and disconnect the hose.


4. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (w/ VSC)

  1. C215473
    Disconnect the 2 connectors.

  1. C215472E01
    Remove the union bolt and disconnect the pressure feed tube from the vane pump.

  1. Remove the gasket from the pressure feed tube.


5. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (w/o VSC)

  1. G038602E01
    Remove the union bolt and disconnect the pressure feed tube from the vane pump.

  1. Remove the gasket from the pressure feed tube.


6. REMOVE VANE PUMP ASSEMBLY (w/ VSC)

  1. C215474
    Remove the 2 bolts and vane pump.


7. REMOVE VANE PUMP ASSEMBLY (w/o VSC)

  1. G038598E04
    Disconnect the connector from the power steering oil pressure switch.

  1. G028304E01
    Remove the 2 bolts and vane pump.

← ON-VEHICLE INSPECTION (from Aug 2013)REMOVAL (from Aug 2014) →