2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. INSTALL FRONT OIL PUMP OIL SEAL

AT05154E01
  1. Using SST and a hammer, tap in a new oil seal.

    SST
    09350-30020   (09351-32140)

    HINT:
    Make sure the oil seal end is flush with the outer edge of the pump body.

  1. Coat the lip of the oil seal with MP grease.


2. FIX FRONT OIL PUMP BODY
  1. Place the oil pump body on the torque converter clutch.


3. INSTALL FRONT OIL PUMP DRIVEN GEAR

D025800E01
  1. Coat the driven gear with ATF.

  1. Install the driven gear to the oil pump body.


4. INSTALL FRONT OIL PUMP DRIVE GEAR

D025799E01
  1. Coat the drive gear with ATF.

  1. Install the drive gear to the oil pump body.


5. INSTALL STATOR SHAFT ASSEMBLY

AT08410E02
  1. Align the bolt holes of the stator shaft with the bolt holes of the oil pump body and install the stator shaft to the oil pump body.

  1. Install the 13 bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }


6. INSTALL CLUTCH DRUM OIL SEAL RING

AT08409E01
  1. Coat 2 new oil seal rings with ATF.

  1. Squeeze the ends of the 2 oil seal rings together with the overlap distance 8.0 mm (0.314 in.) or less, and then install them to the stator shaft groove.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.


7. INSPECT OIL PUMP DRIVE GEAR ROTATION

AT08408E01
  1. Check that the drive gear rotates smoothly.

  1. Remove the oil pump from the torque converter.


8. INSTALL FRONT OIL PUMP BODY O-RING

D025646E01
  1. Install a new O-ring to the oil pump.

← INSPECTION (from Aug 2013)PRECAUTION (Aug 2013 – Jul 2014) →