2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL TRANSMISSION WIRE
  1. Coat a new O-ring with ATF and install it to the transmission wire connector.

  1. Install the transmission wire with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the transmission wire connector.

    HINT:
    Push up the lever until the claw of the transmission wire connector makes a connection sound.


2. CONNECT TRANSMISSION WIRE

  1. C125285E03
    Connect the 7 connectors to the solenoid valves.
    Text in Illustration 
    *1
    Orange
    *2
    Blue

  1. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

    Torque:
    for bolt A:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }
    for bolt B:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    HINT:
    Each bolt length is indicated below.
    12 mm (0.472 in.) for bolt A

    36 mm (1.42 in.) for bolt B


3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY
  1. Coat a new O-ring with ATF and install it to the oil strainer.

  1. Install the oil strainer with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

NOTICE:
Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

  1. Install a new gasket and the oil pan with the 20 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }


5. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR (for 1KD-FTV)
  1. Install the rear engine mounting insulator to the transmission with the 4 bolts.

    Torque:
    65 N*m{ 663 kgf*cm , 48 ft.*lbf }


6. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY (for 1KD-FTV)
  1. Install the frame crossmember to the engine mounting insulator with the 4 set bolts.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

  1. Connect the ends of the frame crossmember to the vehicle with the 4 bolts and 4 nuts.

    Torque:
    72 N*m{ 734 kgf*cm , 53 ft.*lbf }


7. INSTALL FRONT SUSPENSION MEMBER BRACKET LH AND RH (for 1KD-FTV)
  1. Install the front suspension member bracket LH and front suspension member bracket RH with the 8 bolts.

    Torque:
    33 N*m{ 337 kgf*cm , 24 ft.*lbf }


8. ADD AUTOMATIC TRANSMISSION FLUID
  1. Add automatic transmission fluid (Click here).

← INSPECTION (from Aug 2013)COMPONENTS (from Aug 2013) →