2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. INSTALL FRONT OIL PUMP OIL SEAL

  1. D027961E06
    Using SST and a hammer, tap in a new oil seal.
    SST
    09350-30020   (09351-32140)

    HINT:
    Make sure the oil seal end is flush with the outer edge of the pump body.

  1. Coat the lip of the oil seal with MP grease.


2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY
  1. Place the oil pump body on the torque converter clutch.


3. INSTALL FRONT OIL PUMP DRIVEN GEAR

  1. D027959E01
    Coat the driven gear with ATF.

  1. Install the driven gear to the oil pump body.


4. INSTALL FRONT OIL PUMP DRIVE GEAR

  1. D027958E01
    Coat the drive gear with ATF.

  1. Install the drive gear to the oil pump body.


5. INSTALL FRONT OIL PUMP BODY O-RING

  1. D027963E03
    Coat a new O-ring with ATF and install it to the oil pump body.
    Text in Illustration 
    *1
    New O-Ring


6. INSTALL STATOR SHAFT ASSEMBLY

  1. D027953E01
    Align the bolt holes of the stator shaft with the bolt holes of the oil pump body and install the stator shaft to the oil pump body.

  1. Install the 14 bolts.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }


7. INSTALL CLUTCH DRUM OIL SEAL RING

  1. D027952E07
    Coat 3 new oil seal rings with ATF.

  1. Squeeze the ends of the 3 oil seal rings together with an overlap distance of 8 mm (0.314 in.) or less, and then install them to the starter shaft groove.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.

    NOTICE:
    Do not excessively widen the rings.


8. INSPECT OIL PUMP DRIVE GEAR ROTATION

D027962E01
  1. Place the oil pump body on the torque converter clutch.

  1. Check that the drive gear rotates smoothly.

  1. Remove the oil pump assembly from the torque converter clutch.


9. INSTALL AUTOMATIC TRANSMISSION CASE O-RING

  1. D027950E04
    Coat a new O-ring with ATF and install it to the oil pump assembly.
    Text in Illustration 
    *1
    New O-Ring

← INSPECTION (from Aug 2013)PROBLEM SYMPTOMS TABLE (from Aug 2013) →