ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2013
- HINT:
- In a malfunction where the EGR system is always on, black or white smoke may be emitted from the exhaust pipe.
- If this occurs, inspect the EGR system (Click here).
| CHECK FOR LEAKS |
Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.
- NOTICE:
- Detachment or other problems with the engine oil dipstick, filler cap, PCV hose or other components may cause the engine to run improperly.
- Air suction caused by disconnections, looseness or cracks in the parts of the air induction system between the throttle body and cylinder head will cause engine failure or engine malfunctions.
- Detachment or other problems with the engine oil dipstick, filler cap, PCV hose or other components may cause the engine to run improperly.
| CHECK VACUUM PUMP ASSEMBLY |
![]() ![]() |
Disconnect the vacuum hose from the vacuum pump.
Connect the hose of a vacuum gauge to the pump.
Text in Illustration *1
Vacuum Gauge
*2
Plug
Insert a plug into the other hose of the gauge.
Start the engine and warm it up for more than 2 minutes.
With the engine idling, measure the negative pressure of the pump.
- Standard negative pressure:
- Higher than 87 kPa (650 mmHg, 25.6 in.Hg)
Remove the gauge from the pump.
Connect the hose to the pump with the clip.


