2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL FAN AND GENERATOR V BELT

  1. Use the pulley set bolt of the tensioner to rotate the tensioner pulley clockwise, and then install the V belt.

    A223510E01

    Text in Illustration 
    *1
    Crankshaft Pulley
    *2
    Fan Pulley
    *3
    Generator
    *4
    No. 2 Idler Pulley
    *5
    No. 3 Idler Pulley
    *6
    Cooler Compressor
    *7
    Viscous Heater
    -
    -
    *a
    Type A
    *b
    Type C
    *c
    Type B
    *d
    Type D

    NOTICE:
    Make sure that the V belt is set properly on each pulley.

  1. Check that the indicator mark of the V-ribbed belt tensioner (Click here).


2. INSTALL FRONT HEATER BRACKET (for Cold Area Specification Vehicles)
  1. Install the front heater bracket with the 2 bolts.

    Torque:
    25 N*m{ 250 kgf*cm , 18 ft.*lbf }


3. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Install the No. 1 engine under cover with the 4 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }


4. INSTALL FRONT BUMPER LOWER COVER
  1. Install the front bumper lower cover with the clip and 5 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

← INSPECTION (from Aug 2013)ON-VEHICLE INSPECTION (Aug 2013 – Jul 2014) →