2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REPLACEMENT

Removal / installation · Vehicles built from Aug 2013


1. REPLACE TIGHT PLUG

NOTICE:
If water leaks from the tight plug or the plug is corroded, replace it.

  1. Remove the tight plugs.

  1. Apply adhesive to new tight plugs.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    NOTICE:
    Do not start the engine for 1 hour after installation.

  1. Position A:
    Using a 14 mm steel bar and hammer, tap in the tight plug as shown in the illustration.

  1. Other Positions:
    Using SST and a hammer, tap in the tight plugs as shown in the illustration.
    Position B

    SST
    09950-60010   (09951-00180)
    09950-70010   (09951-07100)
    Position C
    SST
    09950-60010   (09951-00190)
    09950-70010   (09951-07100)
    Position D
    SST
    09950-60010   (09951-00200)
    09950-70010   (09951-07100)
    Position E and H
    SST
    09950-60010   (09951-00350)
    09950-70010   (09951-07100)
    Position F
    SST
    09950-60010   (09951-00400, 09951-00450)
    09950-70010   (09951-07100)
    Position G
    SST
    09950-60010   (09951-00450)
    09950-70010   (09951-07100)

    A152216E05
    Text in Illustration 
    *1
    Stops
    -
    -
    *a
    for Right Side
    *b
    for Left Side
    *c
    for Front Side
    *d
    for Rear Side


2. REPLACE STRAIGHT PIN

NOTICE:
It is not necessary to remove the straight pin unless it is being replaced.

  1. Remove the straight pins.

  1. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.

    Standard Protrusion Height:
    Item
    Specified Condition
    Pin A
    6 mm (0.234 in.) or less
    Pin B
    7.5 mm (0.295 in.) or less
    Pin C
    12 mm (0.472 in.) or less
    Pin D
    5 to 8 mm (0.197 to 0.315 in.) or less


    A225495E01
    Text in Illustration 
    *a
    for Front Side
    *b
    for Rear Side
    *c
    for Oil Pan Side
    -
    -


3. REPLACE RING PIN

NOTICE:
It is not necessary to remove the ring pin unless it is being replaced.

  1. Remove the ring pins.

  1. Using a plastic-faced hammer, tap in new ring pins to the cylinder block.

    Standard Protrusion:
    6 mm (0.236 in.) or less


    A152219E03
    Text in Illustration 
    *a
    Cylinder Head Side
    -
    -

← INSPECTION (from Aug 2013)REASSEMBLY (from Aug 2013) →