ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2013
- NOTICE:
- Turn the ignition switch off for 60 seconds before performing the following inspections.
| INSPECT LIGHTING TIME OF GLOW INDICATOR LIGHT |
Turn the ignition switch to ON and measure the length of time that the light remains illuminated.

- Lighting time:
- Refer to the graph
If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plugs and glow plug relay.Text in Illustration *a
Glow Indicator Lighting Time
*b
Engine Coolant Temperature
| INSPECT PRE-HEATING |
Turn the ignition switch to ON and measure the length of time that battery voltage is applied to the glow plugs.

- Pre-heating Time :
Engine Coolant Temperature
Specified Condition
40°C (104°F) or higher
1 second
Below 40°C (104°F)
Refer to the graph
(15 seconds at longest)
If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plugs and glow plug relay.Text in Illustration *a
Pre-heating Time
*b
Battery Voltage
Turn the ignition switch to START, and check that battery voltage is applied to the glow plugs.
While cranking the engine, measure the time that battery voltage is applied to the glow plugs.
- Pre-heating Time:
Engine Coolant Temperature
Specified Condition
40°C (104°F) or higher
1 second
Below 40°C (104°F)
Refer to the graph (15 seconds at longest)
| INSPECT AFTER GLOW TIME |
After starting the engine, measure the time that battery voltage is applied to the terminal SREL of the ECM.

- After glow time:
- Refer to the graph
If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plugs and glow plug relay.Text in Illustration *a
After Glow Time
*b
Engine Coolant Temperature
