2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013

NOTICE:
Turn the ignition switch off for 60 seconds before performing the following inspections.


INSPECT ILLUMINATION DURATION OF GLOW INDICATOR LIGHT

  1. A229539E01
    Turn the ignition switch to ON and measure the length of time that the light remains illuminated.

    Light illumination duration:
    Refer to the graph

    Text in Illustration 
    *a
    Glow Indicator Lighting Time
    *b
    Engine Coolant Temperature
    If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plugs and glow plug relay.


INSPECT PRE-HEATING

  1. A112490E06
    Turn the ignition switch to ON and measure the length of time that battery voltage is applied to the glow plugs.

    Standard Pre-heating Time :
    Engine Coolant Temperature
    Specified Condition
    40°C (104°F) or higher
    1 sec.
    40°C (104°F) below
    Refer to graph*1
    (15 sec. at longest)

    Text in Illustration 
    *a
    Pre-heating Time
    *b
    Battery Voltage
    1. *1: The pre-heating time changes depending on the battery voltage.
    If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plugs and glow plug relay.


INSPECT AFTER GLOW TIME

  1. A229540E01
    After starting the engine starting, measure the time that battery voltage is applied to the terminal GREL of the ECM.

    After glow time:
    Refer to the graph

    Text in Illustration 
    *a
    After Glow Time
    *b
    Engine Coolant Temperature
    If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plugs and glow plug relay.

← SYSTEM DIAGRAM (from Aug 2013)COMPONENTS (from Aug 2013) →