2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
  1. Apply MP grease to a new O-ring.

  1. Install the O-ring to the axle hub.

  1. Install the dust cover and axle hub to the steering knuckle with the 4 bolts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }


2. INSTALL FRONT AXLE SHAFT NUT
  1. Clean the threaded parts on the drive shaft and axle shaft nut using a non-residue solvent.

    NOTICE:
    1. Be sure to perform this work for a new drive shaft.
    2. Keep the threaded parts free of oil and foreign objects.

  1. Install the front axle shaft nut.

    Torque:
    235 N*m{ 2396 kgf*cm , 173 ft.*lbf }

  1. Install the adjusting cap and cotter pin.


3. INSTALL FRONT AXLE HUB GREASE CAP
  1. Install a new axle hub grease cap.

    NOTICE:
    Make sure the grease cap is securely installed to the axle hub.


4. INSTALL FRONT DISC
  1. Align the matchmarks and install the front disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the disc has the smallest runout.


5. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH
  1. Install the disc brake cylinder assembly with the 2 bolts.

    Torque:
    123 N*m{ 1254 kgf*cm , 91 ft.*lbf }

  1. Using a union nut wrench, connect the brake tube to the disc brake cylinder assembly.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).


6. BLEED BRAKE LINE
  1. for Hydraulic Brake Booster:
    Bleed the brake line (Click here).

  1. for Vacuum Brake Booster:
    Bleed the brake line (Click here).


7. CHECK FOR FLUID LEVEL IN RESERVOIR
  1. for Hydraulic Brake Booster:
    Check the brake fluid level in reservoir (Click here).

  1. for Vacuum Brake Booster:
    Check the brake fluid level in reservoir (Click here).


8. CHECK FOR BRAKE FLUID LEAK

9. INSTALL FRONT WHEEL

Torque:
112 N*m{ 1142 kgf*cm , 83 ft.*lbf }


10. ADJUST FRONT WHEEL ALIGNMENT
  1. Adjust the front wheel alignment (Click here).


11. CHECK SPEED SENSOR SIGNAL
  1. Inspect the speed sensor signal (Click here).

← REASSEMBLY (from Aug 2013)COMPONENTS (from Aug 2013) →